Purifier Module, Nitrogen 1/8 Fittings

• Replace separate oxygen, moisture, and hydrocarbon traps with one multiple-bed purifier, specific for purifying helium, hydrogen, nitrogen, or air.
• Reduce gas impurities from ppm to low ppb levels.
• Decrease baseline noise and increase GC-MS sensitivity.
• Prepurged with the specified gas to shorten downtime.

Performance for these purifiers is optimized by incorporating a multiple-bed format that progressively lowers concentrations of contaminants at each successive bed. VICI® Mat/Sen® purifiers are guaranteed to produce gases that are purer than 99.9999%,, when supplied with gas of 99.995%, purity, and are prepurged with the specified gas to speed conditioning. Purifier capacity is approximately four tanks of gas at 99.995%, (50 ppm) purity, and correspondingly longer for purer gases.

Please Note: We recommend using an indicating oxygen trap (e.g., cat.# 22029, pg. ) downstream from a VICI® Mat/Sen® purifier to continually ensure gas purity and indicate absolute change-out time.

Specifications:
Length: 21&Prime, (53.3 cm)
Diameter: 1.5&Prime, (3.8 cm)
Maximum Inlet Pressure: 1,000 psi (6895 kPa)
Maximum Recommended Flow: 500 mL/min
Pressure Drop from 120 psi (827 kPa) inlet at a flow of 0-500 mL/min: <0.20 psi (1.4 kPa)
Compression End Fittings: 1/8&Prime, or 1/4&Prime,, stainless steel
Shipping Weight: 3.04 lb. (1,300 g)
*Warning: Do not use with nitrogen containing more than 500 ppm of oxygen. If the oxygen level in the stream exceeds 500 ppm, use an air purifier.